DNA TOOLS-00173 - Intended Use; Technical Specifiations; Noise;Vibration Information

7
and work with approved safety equipment, such as those dust masks that are
specially designed to filter out microscopic particles.
The machine is intended for lengthways and crossways cutting of wood with straight cutting
lines as well as mitre cuts in wood while resting firmly on the workpiece. With suitable saw
blades, thin-walled non-ferrous metals, e. g., profiles, can also be sawed. Working ferrous
metals is not permitted
INTENDED USE
The machine is intended for lengthways and crossways cutting of wood with straight
cutting lines as well as mitre cuts in wood while resting firmly on the workpiece.
With suitable saw blades, thin-walled non-ferrous metals, e. g., profiles, can also be
sawed. Working ferrous metals is not permitted.
LIST OF MAIN PART
1. On/off switch
2. Lock-off switch
3. Battery capacity indicator
4. Lock knob of depth cut
5. Saw blade cover
6. Lock knob of mitre angle
7. Spindle lock
8. Hex key
TECHNICAL SPECIFIATIONS
Power
12 V
No-load speed
1450 min
-1
Blade size
85mm
Max. Cutting depth
26 mm
Declaration of noise emission
L
pA
: 77,1 dB(A) K=3 dB(A)
L
wA
:88,1 dB(A) K=3 dB(A)
Vibration emission value
a
h
=3,368 m/s
2
K=1,5 m/s
2
NOISE/VIBRATION INFORMATION
Measured sound values determined according to EN 62841.
Wear hearing protection!
Vibration total values (triax vector sum) determined according to EN 62841:
The vibration emission level given in this information sheet has been measured in
accordance with a standardized test given in EN 62841 and may be used to compare
one tool with another.
It may be used for a preliminary assessment of exposure.