10
bevel angle scale.
3. Tighten the bevel adjustment lever.
APPLICATION ADVICE
Please always properly secure the workpiece before working.
For board cutting, please always fix the workpiece in a support surface and make
sure the blade cannot touch with it.
CAUTION!
Never cut the unsecured board!
Ensure that the openings provided for ventilation of the motor are clear.
The number of teeth on the blade may affect the quality of cutting. More tooth, higher
quality.
Please always make pencil line on workpiece and select the correct notch during
working as below photo.
The thickness of blade will affect the cutting position as below photo.
Please always carry out a test before using.
Always remove the battery before carrying out any work on the machine.
Care and cleaning
Keep the ventilation openings clear and clean the product regularly. Clean the
housing only with a damp cloth-do not uses any solvents! Dry thoroughly afterwards.
Caution!
If something unusual occurs during use, switch off the tool and remove the battery.
Inspect and repair the tool before using it again. Repair of the tool must only be
carried out by a qualified repair technician.
Repair or maintenance by unqualified personnel can lead to a risk of injury.
Use only identical spare parts for repairing a tool.
Caution!
Ensure that the batteries are charged using the correct charger recommended by the
manufacturer.
Attention!
After long time storage, the battery capacity will be reduce.
In order to maintain battery capacity, we recommend that only store full charged
batteries and top-up the charge from time to time. They should be stored in a dry and
frost-free place, the ambient temperature should not exceed 40
0
C.
To Next Page
Loading...