9
Ensuring the correct orientation between the battery and the battery compartment,
insert the rechargeable battery into the machine. Do not apply force when inserting
the battery. Insertion can be achieved easily and without resistance. The battery must
be inserted completely until the battery retention clips on the sides of the battery
compartment automatically lock it into place. To remove the battery press the battery
retention clips and pull the battery out of its compartment.
On/Off switch
Use the On/Off switch and lock-off switch to start the machine and keep holding it for
continuous operation.
The machine can only be start by depressing the lock-off switch first to preventing
any unintentional operation.
To switch the machine off, release the On/Off switch.
CAUTION!
Always hold the machine by both hands.
Never start the circular saw with the blade in contact with the workpiece. Start cutting
only after the motor reached its full speed.
Always carry out a test run before starting work and after every tool change! Always
ensure that the tools are in good condition, correctly mounted and able to turn freely.
The trial run should be at last 30 sec.
Vibrating discs must be replaced immediately.
Mounting blade
The mounting hole of blade must fit with the mounting flange. Do not use reducers or
adapters.
The direction-of-rotation arrow on blade and machine (see direction-of-rotation arrow
on the machine enclosure) should be same.
To assembly the blade, using the hex key to loosen the inner hex bolt, refer to above
picture.
Put the blade between two parts of flange and then tighten it with hex key provided.
CAUTION!
Never use blade whose diameter is larger than that indicated.
Never use steel or high speed steel blade for wood cutting in circular saw.
The maximum rotation speed of blade must be greater than the idling speed of the
machine.
Adjusting the cutting depth
For optimal quality of cutting, the saw blade should not extend more than 3 mm
below the workpiece
To adjust the cutting depth (0-26mm), please follow below steps:
1. Loosen the depth locking lever by hand.
2. Raise/lower the base plate and set the blade to the required depth - as shown on
the cutting depth scale.
3. Tighten the depth locking lever.
CAUTION!
Always check the locking lever before working. Loosed locking lever may cause
serious injure.
Adjusting the cutting angle
CAUTION!
When bevel cutting, cutting depth does not correspond with value on cutting depth
scale
Always check the bevel adjustment lever before working. Loosened adjustment lever
may cause serious injure.
To adjust the cutting angle (0-45º), please follow below steps:
1. Loosen the bevel adjustment lever by hand.
2. Adjust the base plate and set the blade to the required angle - as shown on the
To Next Page
Loading...