User Manual C-6000i Computerized Jigging Reel
8
Figure 3
When the reel has been mounted and power applied, the line is fitted on the
drum. Figure 3 shows a typical configuration when fitting the line on the
drum. It should be wound quite densely and hence some resistance to the
pull of the reel is necessary. Fasten the line to the drum (there is a hole in the
drum for that purpose but the cap of the drum must be removed) and press
the MAIN pad two times (to enter Hauling state). The reel will then start
turning the drum and reel in the line slowly. If you are comfortable with more
speed, press the PLUS pad and the power will increase to full hauling power.
Control the reel with one hand the line with the other. Be careful not to get
your hand stuck in the line and wear a glove to protect your hand and
fingers. When the entire line has been fitted on to the drum press the MAIN
pad again to stop the reel. Now the line must be properly threaded (see
Figure 4 on page 9). It is not necessary to use a stop-ring but then a certain
parameter must be set (see section STOP AT ZERO on page 30).
To Next Page
Loading...