REMOTE CONTROL
Built-in Antenna
Shock Button
Beep Button
Toggle Switch
LED Indicator Light
Charging Port
ANTI BARK COLLAR
Contact Point
Vibration Button
3
ON/OFF/Pairing/Sensitivity Button
LED Indicator Light
Charging Port
4
(Dog Channel: 1/2
Anti Bark Mode: A)
The remote has 3 channels: 1and 2 is for the Remote Training Mode.
A is for the Anti Bark Mode. You will use the toggle switch on the
remote to switch between channels.
If you have one dog, you will need to pair to Channel 1 or Channel 2.
If you have two dogs and bought a second collar, you will need to pair
one collar to Channel 1 for one dog and you will need to pair the
second collar to Channel 2 for the second dog.
The three buttons on the remote for beep, vibrate, and shock can be
used for Channel 1, Channel 2, and Channel A.
How to turn the collar off and on
Click the button on the collar once to turn it ON. You will feel a short
vibrate to confirm it has been turned on.
It will stay on when the remote is charging.
It will turn off when the battery is fully charged.
It will flash if you press buttons on the remote.
It will blink every 3 seconds during standby mode until no operations
have been completed for 20 minutes.
Remote LED Indicator Light
Blink twice per second when the remote need to charging.
To turn the collar OFF, quickly double click the button on the collar.
You will feel a long vibrate to confirm it has been turned off.
Intensity Dial
Shock/Vibration
The intensity dial on the remote is used to adjust the level
of vibrate or shock from 0 to 100 for Channel 1, Channel 2.
Turn the dial clockwise to turn the intensity up. 40 levels
is currently intensity in used.
To Next Page
Loading...