Dockin D FINE+ 2 - General Safety Notes; Electrical Shock Hazards; Fire and Explosion Risks; Chemical Burn Hazards

EN EN
14 15
CHANGING THE SOURCE DEVICE/DISCONNECTING
To select a new playback device while still paired, the current
Bluetooth® connection needs to be disengaged.
• Disconnect the current Bluetooth® connection on the source
device.
or
• Push and hold the
button on your DFINE+ 2 for approx. 3
seconds.
TURNING THE D FINE+ 2 OFF
• Hold the button on the top of your DFINE+ 2 down for 3
seconds to switch the DFINE+ 2 off.
• The current charging status is visible via the battery LED for 15
seconds after turning the unit off.
CHARGING THE D FINE+ 2
Charge your D FINE + by using the provided power cable. The
charging input is located behind the cover on the back.
0 - 10% 11 - 30% > 30%
During charging the battery LED blinks in the corresponding color
to signal charging in progress. Once the device is completely
charged, the LED lights up permanently green.
AUX-MODE
You can connect your D FINE+ 2 to a source device using the
provided AUX cable (3.5mm plug cable).
The D FINE+ 2 power-saving mode is disengaged when the AUX
cable is connected. If the AUX cable and the mains adapter are
connected, this permits stationary use, for example as a PC speaker
or a TV soundbar.
1. Connect the source device to the AUX input of your DFINE+ 2
using the provided 3.5mm plug cable.
2. Start playback on the source device.