Dockin D Pure - Usage and Connectivity; Power Off; Volume and Track Control; Incoming Call Handling

14 15
EN EN
POWER OFF
• Slide the power switch
7
back to its original position to turn o
the headphones completely.
Then the power status LED will turn o immediately.
VOLUME UP / NEXT TRACK:
• Short Press Button
1
: Volume up by one level
• Highest Volume Level reached: You will hear a prompt tone
• Long Press Button
1
: Next Track
VOLUME DOWN / PREVIOUS TRACK:
• Short Press Button
3
: Volume down by one level
• Lowest Volume Level reached: You will hear a prompt tone
• Long Press Button
3
: Previous Track
INCOMING CALLS:
• The music will be muted for incoming calls.
• Receiving incoming calls: Press the multifunction button
2
once
• To end a call: Press the multifunction button
2
once
• Reject incoming call: Long press the multifunction button
2
• Redial the last phone number dialed: Double click the multifunc-
tion button
2
USAGE AND CHARGING
• The rechargeable battery is built into the device. Fully charge
the headphones before rst use.
• Battery Low: A voice message is heard “Battery is too low” and
the status LED turns red. In that case, please charge your
headphones as soon as possible.
• The headphones must be turned o to charge. Insert the
charging cable into the charging port. During charging, the
Power Status LED turns red and changes to green when the
headphones are fully charged.
BLUETOOTH AND AUX INPUT
• The headphones can be used via Bluetooth as well as via AUX
connection.
• When the jack cable is plugged into the AUX port, the Bluetooth
connection is automatically disabled and the device turns o.
• While using the AUX connector, the Bluetooth connection is
always disabled.
• When the battery is empty, the headphones can be used for
music listening via the AUX port.