DOD VoTec - User Manual

WARNING
FOR YOUR PROTECTION, PLEASE READ THE FOLLOWING:
WATER AND MOISTURE: Appliance should not be used near water (e.g. near a
bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming
pool, etc). Care should be taken so that objects do not fall and liquids are not spilled
into the enclosure through openings.
POWER SOURCES: The appliance should be connected to a power supply only of
the type described in the operating instructions or as marked on the appliance.
GROUNDING OR POLARIZATION: Precautions should be taken so that the ground-
ing or polarization means of an appliance is not defeated.
POWER CORD PROTECTION: Power supply cords should be routed so that they are
not likely to be walked on or pinched by items placed upon or against them, paying
particular attention to cords at plugs, convenience receptacles, and the point where
they exit from the appliance.
SERVICING: To reduce the risk of fire or electric shock, the user should not attempt
to service the appliance beyond that described in the operating instructions. All other
servicing should be referred to qualified service personnel.
FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSIBLE FUSE RECEPTACLE:
Replace fuse with same type and rating only.
ELECTROMAGNETIC COMP
ATIBILITY
Operation is subject to the following conditions:
• this device may not cause harmful interference, and
• this device must accept any interference received, including interference
that may cause undesired operation.
• use only shielded interconnecting cables.
• operation of this unit within significant electromagnetic fields should be
avoided.
CAUTION
ATTENTION: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE
RISK OF ELECTRIC SHOCK
DO NOT OPEN

Summary

General Safety and Warning Information

Water and Moisture Precautions

Advises against using the appliance near water and warns about liquid ingress.

Power Source and Grounding Guidelines

Covers correct power supply connection and importance of grounding/polarization.

Power Cord and Servicing Recommendations

Details power cord protection and user limitations for appliance servicing.

Fuse Replacement Instructions

Specifies using only the same type and rating for fuse replacement.

Electromagnetic Compatibility (EMC)

EMC Operation Conditions

Outlines conditions for operation, including interference acceptance and cable use.

Operating the VoTEC

Selecting Programs and Banks

Explains how to select programs and banks using footswitches and Up/Down buttons.

Editing and Saving User Programs

Details the process for editing, saving, and removing effects in user programs.

Bypassing the VoTEC Unit

Describes how to bypass the entire VoTEC effect and re-engage it.

Factory Reset Procedure

Provides instructions for resetting the VoTEC to its original factory default settings.

Product Information and Warranty

VoTEC Accessories Overview

Illustrates and names optional accessories for the VoTEC unit.

Declaration of Conformity Details

Lists manufacturer, product details, and compliance with safety and EMC directives.

VoTEC Product Warranty Terms

Outlines warranty registration, coverage, limitations, and proof-of-purchase requirements.

VoTEC Control Panel Overview

Program and Bank Selector Footswitches

Explains the function of the footswitches for program and bank selection.

Power Input and Optional Controller

Details the power adaptor input and connection for the optional VCC1 controller.

Effect Selector and Display Functions

Describes the effect selector buttons and the LED display for program/effect status.

Store Button and Bypass Operation

Explains the store button for saving programs and how effects can be bypassed.

Input;Output Connections and Controls

Details XLR inputs/outputs, Input knob, Clip LED, and 1/4" HiZ jacks.

Navigation and Parameter Adjustment Buttons

Describes the Up/Down buttons for scrolling through effects and banks/presets.

Factory Presets and FX List

Detailed List of Factory Preset Banks

Lists the presets available across 10 banks, including names and associated effects.

Effects List and Parameter Ranges

Details available effects like Modulations, Delay, Reverb, Compression, Distortion, and EQ.

Quick Start Guide

Initial Safety and Connection Steps

Covers reading safety info, connecting microphone input, and output to mixer.

Power and Input Level Setup

Ensures correct power adaptor connection and setting the initial input level.

Accessing Banks and Presets

Guides users on navigating and selecting presets using the footswitches.

DOD VoTec Specifications

General

Brand	DOD
Model	VoTec
Category	Recording Equipment
Language	English