132
Controls in detail
Tempmatic
3
Heating
Set temperature selector control 1
( page 131) as required, but do not
turn the control below the middle posi-
tion.
Set airflow control 2 ( page 131) as
required, but do not turn the control
below the second speed.
Set the air distribution control as
shown.
Close the center air vents.
Close the air vents.
Open the side air vents half-way and di-
rect them at the side windows.
Ventilation
This setting rapidly ventilates the vehicle
interior.
Turn temperature selector control 1
( page 131) to the lowest setting
(maximum cooling).
Set airflow control 2 ( page 131) as
required, but do not turn the control
below the second speed.
Set air distribution control 5
( page 131) to h.
Open as required:
the center air vents
the side air vents
the ventilation vents
Press the ° switch.
The indicator lamp in the switch comes
on. The air-conditioning system is
switched off.
The temperature is set using temperature
selector control 1 in the control panel
( page 131).
The recommended setting for the target
temperature is 72.0 °F (22.2 °C) under
normal conditions, to which Tempmatic
adjusts as rapidly and as comfortably as
possible.
Only change the temperature in small in-
crements.
To increase: turn the temperature se-
lector control clockwise.
To reduce: turn the temperature selec-
tor control slightly counterclockwise.
Basic setting
N83.40-2060-31
Setting the temperature
i
If you use the basic settings for heating
or ventilating the vehicle, you will only
rarely need to adjust the temperature,
airflow and air distribution
( page 132).
To Next Page
Loading...
