59
Controls in detail
Opening and closing
3
Opening/closing using the inside and
outside door handles
Observe the notes on anti-trap protection
( page 60).
1 Button
2 Outside door handle
Briefly press button 1 or pull outside
door handle 2.
The sliding door opens or closes and a
signal sounds.
Press button 1 again or pull outside
door handle 2 again.
The sliding door stops.
Opening/closing with the remote con-
trol
Press and hold the button for
more than half a second.
The sliding door unlocks and opens or
closes.
Press the button again.
The sliding door stops.
Programming the remote control
If the vehicle is equipped with 2 sliding
doors, it is only possible to program the re-
mote control for one of the sliding doors.
1 Switch for sliding door on left-hand
side
2 Switch for sliding door on right-hand
side
Make sure that the doors are closed.
Switch on the ignition ( page 67).
Press and hold the upper part of
relevant switch 1 or 2 on the center
console for 5 seconds.
The indicator lamp in the switch for the
sliding door concerned flashes and a
warning tone sounds three times as
confirmation.
N72.16-2118-31
N72.16-2136-31
To Next Page
Loading...
