97
Controls in detail
Operating system with steering wheel buttons*
3
Resetting the functions of a submenu
You can reset the functions of an individual
submenu to the factory defaults.
Select a function in a submenu.
Press reset button for approximate-
ly 3 seconds.
You will see the message in the display
prompting you to press the reset
button once more to confirm.
Press reset button again.
Most functions in the submenu are re-
set to the factory defaults.
Submenus in the Settings menu
Press the j button.
You will see the collection of sub-
menus. There are more submenus than
can be displayed at the same time.
Press ç button.
The selection marker moves to the next
submenu.
The submenus are arranged in a hierarchy;
press the ç button to scroll down,
press the æ button to scroll up.
You can select a function within the sub-
menus by pressing the j button.
The settings themselves are changed by
pressing the æ or ç button again.
This table shows the settings you can
make in the individual submenus.
You will find additional information on the
following pages.
i
If you do not press the reset button
a second time to confirm, the changed
settings remain set. The
Settings
menu is displayed again after approxi-
mately 5 seconds.
For safety reasons, it is not possible to
reset all of the functions while the vehi-
cle is in motion. For example, the
Hdlmp. mode
function in the
Lighting
submenu remains unchanged.
N54.32-2255-31
To Next Page
Loading...
