Power Lumbar
• Push the switch forward to increase the
lumbar support. Push the switch rear -
ward to decrease the lumbar support.
• Pushing upward or downward on the
switch will raise and lower the position of
the support.
Memory Seat
The memory seat feature allows you to set two different driver seating positions (excluding
lumbar position), outside mirrors, radio station preset settings and tilt/telescoping steer -
ing column position (if equipped). The memory seat buttons are located on the driver's
door panel.
To set a memory position:
1. Cycle the vehicles ignition to the ON
position.
2. Adjust all memory profile settings.
3. Push and release the S (SET) button.
4. Push and release the 1 or 2 button
within five seconds.
NOTE:
Before programming your RKE transmitters
you must select the “Personal Settings
Linked To Key Fob” feature through the
Uconnect
®
system. Refer to “Uconnect
®
Settings ” in “Understanding Your Instru-
ment Panel” in the Owner's Manual on the
DVD for further details.
Power Lumbar Switch
Memory Seat Buttons
GETTING STARTED
28
To Next Page
Loading...
