get a better fit. If the rear seat can be moved forward and rearward in the vehicle, you
may wish to move it to its rear-most position to make room for the child seat. You may
also move the front seat forward to allow more room for the child seat.
3. Attach the lower hooks or connectors of the child restraint to the lower anchorages in
the selected seating position.
4. If the child restraint has a tether strap, connect it to the top tether anchorage. See the
section “Installing Child Restraints Using The Top Tether Anchorage” for directions to
attach a tether anchor .
5. Tighten all of the straps as you push the child restraint rearward and downward into the
seat. Remove slack in the straps according to the child restraint manufacturer’s
instructions.
6. Test that the child restraint is installed tightly by pulling back and forth on the child
seat at the belt path. It should not move more than 1 inch (25.4 mm) in any direction.
How To Stow An Unused Switchable-ALR (ALR) Seat Belt
When using the LATCH attaching system to install a child restraint, stow all ALR seat belts
that are not being used by other occupants or being used to secure child restraints. An
unused belt could injure a child if they play with it and accidentally lock the seat belt
retractor. Before installing a child restraint using the LATCH system, buckle the seat belt
behind the child restraint and out of the child’ s reach. If the buckled seat belt interferes
with the child restraint installation, instead of buckling it behind the child restraint, route
the seat belt through the child restraint belt path and then buckle it. Do not lock the seat
belt. Remind all children in the vehicle that the seat belts are not toys and that they should
not play with them.
WARNING!
• Improper installation of a child restraint to the LATCH anchorages can lead to failure
of the restraint. The child could be badly injured or killed. Follow the child restraint
manufacturer’s directions exactly when installing an infant or child restraint.
• Child restraint anchorages are designed to withstand only those loads imposed by
correctly-fitted child restraints. Under no circumstances are they to be used for adult
seat belts, harnesses, or for attaching other items or equipment to the vehicle.
GETTING STARTED
45
To Next Page
Loading...
