Dodge CHALLENGER 2020 - To Cancel; To Turn off; To Resume; To Vary the Speed Setting

182 STARTING AND OPERATING
TO CANCEL
The following conditions cancel the system:
 The brake pedal is applied.
 The CANC (cancel) button is pushed.
 The vehicle speed goes below 15 mph
(24 km/h).
 An Anti-Lock Brake System (ABS) event occurs.
 The gear selector is removed from the DRIVE
position.
 The Electronic Stability Control/Traction
Control System (ESC/TCS) activates.
 The vehicle parking brake is applied.
 The driver switches ESC to Full Off mode.
TO TURN OFF
The system will turn off and clear the set speed
in memory if:
 The Adaptive Cruise Control (ACC) on/off
button is pushed.
 The Normal (Fixed Speed) Cruise Control on/
off button is pushed.
 The ignition is placed in the OFF position.
TO RESUME
If there is a set speed in memory push the RES
(resume) button and then remove your foot
from the accelerator pedal. The instrument
cluster display will display the last set speed.
NOTE:
ACC cannot be resumed if there is a stationary
vehicle in front of your vehicle in close proximity.
TO VARY THE SPEED SETTING
To Increase Speed
While ACC is set, you can increase the set speed
by pushing the SET (+) button.
The driver's preferred units can be selected
through the instrument cluster display. Refer to
“Getting To Know Your Instrument Panel” for
more information. The speed increment shown
is dependent on the chosen speed unit of
U.S. (mph) or Metric (km/h):
U.S. Speed (mph)
 Pushing the SET (+) button once will result in
a 1 mph increase in set speed. Each subse-
quent tap of the button results in an increase
of 1 mph.
 If the button is continually pushed, the set
speed will continue to increase in 5 mph
increments until the button is released. The
increase in set speed is reflected in the
instrument cluster display.
Metric Speed (km/h)
 Pushing the SET (+) button once will result in
a 1 km/h increase in set speed. Each subse-
quent tap of the button results in an increase
of 1 km/h.
 If the button is continually pushed, the set
speed will continue to increase in 10 km/h
increments until the button is released. The
increase in set speed is reflected in the
instrument cluster display.
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming
a set speed that is too high or too low for
prevailing traffic and road conditions could
cause the vehicle to accelerate or decelerate
too sharply for safe operation. Failure to
follow these warnings can result in a collision
and death or serious personal injury.
20_LA_OM_EN_USC_t.book Page 182