Dodge DART - Uconnect Voice Command

Memo Mode To switch to the voice recorder mode, say “Memo”.
The following are common voice commands for this
mode:
“New Memo” (to record a new memo) — During the
recording, you may press the Voice Command button
to stop recording.You proceed by saying one of
the following commands:
• “Save” (to save the memo)
• “Continue” (to continue recording)
• “Delete” (to delete the recording)
•
Play Memos” (to play previously recorded memos) —
During the playback you may press the Voice Com-
mand button
to stop playing memos. You
proceed by saying one of the following commands:
• “Repeat” (to repeat a memo)
• “ Next” (to play the next memo)
• “Previous” (to play the previous memo)
• “Delete” (to delete a memo)
• “Delete All” (to delete all memos)
NOTE:
Refer to your vehicle Owner's Manual on the DVD for further details on Voice Command.
Voice Text Reply
• If equipped with Uconnect® Voice Command, your radios may be able to play incoming
Voice Text Reply messages (text messages) through the vehicle's sound system.
• It also allows you to respond by selecting from various pre-defined phrases.
• Not all phones are compatible with this feature. Refer to the phone compatibility list at
www.UconnectPhone.com. Connected mobile phones must be bluetooth-compatible,
and paired with your radio.
• Press the “Voice Command” button
and after the BEEP, say “SMS” to get started.
NOTE:
To access the tutorial, press the “Voice Command” button
. After the BEEP, say
“tutorial”. Press any hard-key/button or touch the display (Touch-Screen radio) to cancel the
tutorial.
ELECTRONICS
44