EasyManua.ls Logo

Dodge DART - Uconnect 8.4 Customer Programmable Features; UNIVERSAL GARAGE DOOR OPENER (Homelink)

Dodge DART
132 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Uconnect® 8.4 Customer Programmable Features
The Uconnect® 8.4 system allows you to access Customer Programmable feature set-
tings such as Display, Clock, Safety/Assistance, Lights, Doors & Locks, Heated Seats,
Engine Off Operation, Compass Settings, Audio, Phone/ Bluetooth and SiriusXM™ Setup
through soft-keys.
Touch the More soft-key to on the bottom of the screen, then touch the Settings soft-key
to access the Settings screen. When making a selection, scroll up or down until the
preferred setting is highlighted, then press and release the preferred setting until a
check-mark appears next to the setting, showing that setting has been selected. The
following feature settings are available:
Display Clock
Safety / Assistance Lights
Doors & Locks Auto-On Comfort & Remote Start
Engine Off Options Compass Settings
Audio Phone / Bluetooth
SiriusXM™ Setup
UNIVERSAL GARAGE DOOR OPENER (HomeLink®)
HomeLink® replaces up to three hand-held transmitters that operate devices such as garage
door openers, motorized gates, lighting or home security systems. The HomeLink® unit is
powered by your vehicles 12 Volt battery.
The HomeLink® buttons that are located in the overhead console or sunvisor designate
the three different HomeLink® channels.
The HomeLink® indicator is located above the center button.
Before You Begin Programming HomeLink®
Be sure that your vehicle is parked outside of
the garage before you begin programming.
For more efficient programming and accu-
rate transmission of the radio-frequency
signal it is recommended that a new bat-
tery be placed in the hand-held transmitter
of the device that is being programmed to
the HomeLink® system.
Erase all channels before you begin pro-
gramming. To erase the channels, place
the ignition switch into the ON/RUN position, then press and hold the two outside
HomeLink® buttons (I and III) for up 20 seconds or until the red indicator flashes.
ELECTRONICS
74

Table of Contents

Related product manuals