6. Uconnect will prompt you “Please say the message that you would like to send.” (If you
do not hear this prompt, you may not have an active subscription with Uconnect
Access).
7. Wait for the beep, and then dictate any message up to 140 characters. If you exceed
140 characters, you will hear the following prompt: “Message was too long; your
message will be truncated.”
8. Uconnect will then repeat the message back to you.
9. Uconnect will prompt you: “To add to your message, say “Continue”; To delete the
current message and start over , say “Start Over”; to send the current message, say
“Send”; to hear the message again, say “Repeat”.
10. If you are happy with your message and would like to send it, wait for the beep and
say “Send”.
11. Uconnect will then say “Sending your message.”
Sample Commands For Voice Text Reply And Voice Texting
Example Command Action
“Text John Smith”
Send a message to specific contact in
address book
“Text 123 456 7890”
Send 123 456 7890 a message from your
phonebook
“Show messages”
See recent text messages listed by number
on Uconnect screen
“Listen to/view
(message number four , for example)”
Hear messages or read it on Uconnect
screen
“Reply” Send a voice text reply to a current message
“Forward text/message to “John Smith”
Forward current text to specific contact in
address book
“Forward text/message to “123 456 7890”
Forward current text to specific phone
number
ELECTRONICS
90
To Next Page
Loading...
