NOTE:
If the transmission is not in PARK and the vehicle is in motion, the ENGINE START/STOP
button must be held for two seconds with the vehicle speed above 5 mph (8 km/h) before
the engine will shut off.
Accessory Positions With Engine Off
NOTE:
The following functions are with the driver’ s foot off of the Brake Pedal (transmission in
PARK).
Beginning With The Ignition Switch In The OFF Position:
1. Push the ENGINE ST AR T/STOP button once to cycle the ignition to the ACC position.
2. Push the ENGINE ST AR T/STOP button a second time to cycle the ignition to the
ON/RUN position.
3. Push the ENGINE ST ART/STOP button a third time to return the ignition to the OFF
position.
NOTE:
If the ignition is left in the ACC or ON/RUN
(engine not running) position and the trans-
mission is in PARK, the system will auto-
matically time out after 30 minutes of inac-
tivity, and the ignition is returned to the OFF
position.
VEHICLE SECURITY ALARM
The V ehicle Security Alarm monitors the vehicle doors for unauthorized entry and the
ignition for unauthorized operation. While the Vehicle Security Alarm is armed, interior
switches for door locks and decklid release are disabled. If something triggers the alarm,
the Vehicle Security Alarm will provide the following audible and visible signals: the horn
will pulse, the park lamps and/or turn signals will flash, and the V ehicle Security Light in
the instrument cluster will flash.
To Arm
Cycle the Keyless Enter -N-Go ST ART/STOP button until the button display indicates that
the vehicle ignition is “OFF.” Push the power door lock switch while the door is open, push
the Key Fob LOCK button, or with one of the Key Fobs located outside the vehicle and
within 5 ft (1.5 m) of the driver's and passenger front door handles, push the Keyless
Enter -N-Go LOCK button located on the door handle.
NOTE:
After pushing the Keyless Enter-N-Go LOCK button, you must wait two seconds before you
can lock or unlock the vehicle via the door handle.
Ignition Positions
GETTING STARTED
15