A WORD ABOUT YOUR KEYS
Your vehicle uses a keyless ignition system. This system
consists of a Key Fob with Remote Keyless Entry (RKE)
transmitter (RKE Key Fob) and a Keyless Push Button
Ignition.
Keyless Enter-N-Go Feature — Passive Entry
This vehicle is equipped with the Keyless Enter-N-Go —
Passive Entry feature (refer to ⬙Keyless Enter-N-Go —
Passive Entry⬙ in ⬙Things To Know Before Starting Your
Vehicle⬙ for further information).
Keyless Push Button Ignition
This feature allows the driver to operate the ignition
switch with the push of a button, as long as the RKE Key
Fob is in the passenger compartment.
The Keyless Push Button Ignition has four operating
positions; three of which are labeled and will illuminate
when in position. The three positions are OFF, ACC, and
ON/RUN. The fourth position is START, during start
RUN will illuminate.
NOTE: In case the ignition switch does not change with
the push of a button, the RKE Key Fob may have a low or
dead battery. In this situation, a back up method can be
used to operate the ignition switch. Put the nose side
(side opposite of the emergency key) of the RKE Key Fob
against the ENGINE START/STOP button and push to
operate the ignition switch.
14 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
To Next Page
Loading...
