NOTE: Resurfacing of the rotors is not recommended, as it removes
mass from the rotor , reducing its thermal capacity. Resurfacing also
thins the rotor cheek, making it less robust and increasing the likelihood
of pulsation in further track use.
Shift Light
Your vehicle is equipped with a shift light feature that illuminates the back
lighting of the tachometer (in red) within the instrument cluster display.
This feature is a visual cue to manually up-shift using the paddle shifters or
shifting the transmission gear selector.
To actuate the Shift Light feature, press the “Shift Light” button on the
touchscreen, then press the “Shift Light On” button on the touchscreen.
Activation is shown on the instrument cluster display. Pressing the “Shift
Light RPM Set-Up” button on the touchscreen will take you to the Shift
Light RPM Set-Up screen.
NOTE: You must have the shifter in the manual position (left of Drive), or
have paddle shifters enabled for the shift light feature to work.
The Shift Light RPM Set-Up allows you to set the shift light to illuminate for
gears 1, 2, 3, 4, and 5-8. Pressing and releasing the up/down arrow buttons
above and below each listed gear, the RPM values will change in incre-
ments of 250 RPM. The Shift Light setup screen may only be accessed if
the feature is enabled, press the “Reset to factory default” button on the
touchscreen to change back to factory settings, or press the “Shift Light
Off” button on the touchscreen to turn the system off completely.
Shift Light RPM Set-Up
SRT DRIVE MODES
30
To Next Page
Loading...
