SEALER INFORMATION
ALL REPAIRS WHERE PANELS WERE REPLACED HAVE VOIDS THAT MUST
BE FILLED WITH SEALANT. SEALANT SHOULD BE APPLIED TO ALL SKIPS,
PIN HOLES, IN SEALERS AND WELD BURN THROUGH HOLES ON THE INTE-
RIOR AND EXTERIOR OF TH VEHICLE THAT WOULD PERMIT LEAKAGE OF
WATER, AIR OR EXHAUST FUMES. TYPICAL AREAS OF THE EXTERIOR THAT
MUST BE SEALED ARE LISTED IN THIS SECTION. AREAS OF THE INTERIOR
THAT MUST BE SEALED ARE FLOOR PANS, WHEELHOUSES, DASH PANEL,
AND COWL SIDES.
SEALER AMOUNT/BEAD SIZE
4mm DIA* X 1000mm
PUMPABLE
* = DIAMETER
APPLICATION RECOMMENDATIONS
Back to Index
To Next Page
Loading...
