Uconnect® RH3
Enable Or Disable Clock
1. Press the DISP button for more than two seconds to enable or disable the Clock.
2. When this function is enabled, the display shows the message "CLK ON" and the
clock is displayed whenever the ignition is On, even with the radio Off. In
10 seconds if no radio key is pressed, the display returns to the clock.
3. When this function is disabled, the message "CLK OFF" is displayed on the radio
display.
NOTE:
This procedure sets the time on the radio clock ONLY. To set the time in the
Electronic Vehicle Information Center, please refer to the section titled Electronic
Vehicle Information Center (EVIC) in this manual.
Uconnect® RH3
ELECTRONICS
29
To Next Page