3. Placement of the Jack:
•
When changing a front wheel, place the scissors jack
under the rear portion of the lower control arm as
shown below.
•
Operate the jack using the jack drive tube and the
wheel wrench. The tube extension, may be used, but
is not required.
•
When changing a rear wheel, assemble the jack
drive tube to the jack and connect the drive tube to
the extension tube. Place the jack under the axle
between the spring and the shock absorber with the
drive tubes extending to the rear.
•
Connect the jack tube extension and wheel wrench.
234 WHAT TO DO IN EMERGENCIES
To Next Page
Loading...
