CODE XJZ
182
PARTITION PRE-INSTALLATION
PARTITION/WALLS
Pre-installation
(provisions) for
bulkhead
Details and Technology
Mounting holes are provided in the B-pillar roof bows to allow retrofitting of a bulkhead or partition. There
are also apertures for the bulkhead in the B-pillar and B-pillar trim. If no bulkhead is fitted, there is a gap
between the trim and the body shell.
Benefits and Arguments
• Allows retrofitting of a bulkhead
The pre-installation allows body manufacturers to retrofit either a Mopar
®
bulkhead or their own
customized solution.
Remarks
If the vehicle will be built without the pre-installation prep, there is no gap in the B-pillar trim.
Mopar is a registered trademark of DaimlerChrysler Corporation.
To Next Page
Loading...
