18
19
1. Charge the unit before using the unit for the first time.
2. Do not charge the batteries near any flammable
substances.
3. Fully charge the batteries if the unit is to be stored
without use for a period of 3 months or more.
Recharge the Unit If:
• The LED indicator light on the receiver/collar is emitting
a red color.
• If the 3 bar indicator on the transmitter LCD shows just 1
bar.
• The indicator light on the transmitter or receiver will not
come on.
• The indicator light on the transmitter or receiver comes
on momentarily, but will not stay on when the Constant
button is pushed.
7. Charging the Battery
Battery Charging Procedure
The 1900S uses lithium polymer batteries.
The battery charger and charging cables allow you to
charge both the transmitter and receiver at the same
time. The battery charger is designed for a 120 volt wall
outlet.
Note 1:
Only use Dogtra-approved lithium polymer
batteries and chargers for your Dogtra e-collar. This
will prevent any damage that can be incurred from
attempting to use a different charger.
Note 2:
The unit has a partial charge when it leaves the
Dogtra facility. Upon receipt of the collar, be sure to give
it a full 2-hour initial charge before the first use. When
a charger is not in use, disconnect it from the power
source.
To Next Page
Loading...
