29
4. When pairing is complete,
the LED light on the receiver
flashes every 4 seconds.
2. With the receiver turned o,
hold the on/o button on the
receiver until the LED light
begins to rapidly blink green.
1. Turn the transmitter on (or
leave on after code setting
the transmitter).
Set the Selector Dial
to level 1.
Turn on
Receiver Code Setting
Attention!
Do not code both receivers to the same side.
3. On the transmitter,
simultaneously press the
bottom two buttons of Dog 1's
side you selected.
For the second receiver, repeat
and press the bottom two
buttons of the opposite side of
which you coded Dog 1.
or
1
2
To Next Page
Loading...
