Need help?Do you have a question about the Dolby Laboratories DP571 and is the answer not in the manual?
General| Surround Sound | Yes |
|---|---|
| Sample Rates | 48 kHz |
| Bit Depth | 20-bit |
| Dynamic Range Control | Yes |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Audio Outputs | AES/EBU |
| Audio Delay | Adjustable |
| Connectors | BNC, XLR |
| Dimensions | 1.75 x 19 x 14 inches |
Instructions for unpacking and inspecting the unit.
Discusses Dolby E's digital I/O, connectors, and signal characteristics.
Explains the front panel controls, menus, and display.
A guide for immediate encoding and decoding setup.
Details on checking and replacing fuses for safety.
Discusses AES3-ID and SMPTE-276M digital audio interface standards.
Describes how to navigate menus and use push-buttons for operation.
Specifies the channel input configuration for 5.1-channel signals.
Configuration for film audio applications.
Typical postproduction configuration using Dolby E.
Guide to the DP571's setup mode menus and parameters.
Describes the digital audio inputs and loop-through connections.
Details the encoded Dolby E bitstream output.
Configures program settings for the DP571 encoder.
Discusses 16-bit and 20-bit operation capabilities and limitations.
Sets Dolby Digital metadata parameters for the DP571.
Details the hardware connectors and block diagram of the DP572.
Guide to the DP572's setup mode menus and parameters.
Settings for the operating mode of the DP572.
Describes the main signal input for Dolby E or PCM.
Details the analog composite video reference signal requirements.
Details the AES3 outputs for decoded audio.
Specifies the audio encoding method used.
Details the audio frequency response of the system.
Specifies distortion levels for the audio.
To Next Page