Dolmar PM-461 User Manual (English)

Questions and Answers:

R
Ryan FrostAug 18, 2025
Why Dolmar PM-461 engine does not start?
- M
  Micheal MillerAug 18, 2025
  The Dolmar Lawn Mower engine might fail to start due to several reasons. The throttle chock may not be in the correct position; adjust it accordingly. The fuel tank could be empty; refill it. A dirty air cleaner element can also prevent starting, so clean it. Check if the spark plug is loose and tighten it to 25 - 30 Nm if necessary. Ensure the spark plug wire is properly connected. The spark plug gap might be incorrect; set it between 0.7 to 0.8 mm. The spark plug itself could be defective, or the carburetor might be flooded with fuel; in the latter case, remove the air cleaner element and pull the starter rope until the carburetor clears.
M
Mark StewartAug 20, 2025
What to do if Dolmar PM-461 Lawn Mower engine is difficult to start or loses power?
- L
  Lisa YoungAug 20, 2025
  If your Dolmar Lawn Mower engine is hard to start or loses power, the issue might be due to dirt, water, or stale fuel in the tank; drain the fuel and clean the tank, then refill with fresh fuel. Another possibility is a plugged vent hole in the fuel tank cap; clean or replace the cap. A dirty air cleaner element can also cause these symptoms; clean the air cleaner element.
L
lherreraAug 26, 2025
What to do if Dolmar PM-461 vibrates abnormally?
- C
  Christopher BlanchardAug 26, 2025
  Abnormal vibration in your Dolmar Lawn Mower may be due to a loose cutting assembly; tighten the blade. Alternatively, the cutting assembly might be unbalanced; in this case, balance the blade.
L
Lynn SmithAug 28, 2025
Why is my Dolmar PM-461 Lawn Mower engine overheating?
- W
  wpierceAug 28, 2025
  Your Dolmar Lawn Mower engine might be overheating because the cooling airflow is restricted; remove any debris from the slots in the shroud, blower housing, and air passages. Another cause could be an incorrect spark plug. For PM-410, install an RJ19LM spark plug and cooling fins on the engine. For PM-461, install an RJ19LMC spark plug and cooling fins on the engine.
D
David Blake DDSAug 30, 2025
Why Dolmar PM-461 engine operates erratically?
- D
  David ParkAug 30, 2025
  An erratic engine operation in your Dolmar Lawn Mower could be due to a defective spark plug. Install a new, correctly gapped plug. The spark plug gap might also be incorrect; set the gap between electrodes at 0.7 to 0.8 mm. Another potential cause is a dirty air cleaner element.
R
Randy WashingtonSep 2, 2025
Why Dolmar PM-461 engine idles poorly?
- Y
  ypattersonSep 2, 2025
  Poor idling in your Dolmar Lawn Mower engine can be caused by a dirty air cleaner element. Additionally, blocked air slots in the engine shroud or blocked cooling fins and air passages under the engine blower housing can contribute to this issue. Remove debris from the slots, cooling fins, and air passages to resolve the problem.
B
Brad CainSep 4, 2025
What causes Dolmar PM-461 Lawn Mower engine to skip at high speed?
- S
  smithjeanneSep 5, 2025
  If your Dolmar Lawn Mower engine skips at high speed, the gap between the electrodes of the spark plug might be too close. Set the gap between the electrodes to 0.7 to 0.8 mm.
G
gary57Sep 7, 2025
Why does my Dolmar PM-461 engine operate erratically?
- E
  eric99Sep 7, 2025
  If the Dolmar Lawn Mower engine operates erratically, the spark plug may be defective. Replace it with a new, correctly gapped plug, referring to the ENGINE OWNER’S MANUAL. Also, the spark plug gap may be incorrect; set the gap between the electrodes at 0.7 to 0.8 mm. A dirty air cleaner element can also cause this issue; clean the air cleaner element according to the ENGINE OWNER’S MANUAL.
Z
Zoe BarajasSep 10, 2025
What causes a Dolmar PM-461 to vibrate abnormally?
- H
  hilldianaSep 10, 2025
  If your Dolmar Lawn Mower vibrates abnormally, the cutting assembly (blade) may be loose. Tighten the blade to secure it. If the vibration persists, the cutting assembly may be unbalanced. Balance the blade to reduce the vibration.