Turning the Dolphin ON
Part 3 - Taking the Dolphin out of the water
Unplug power supply before any servicing activity.
If the Dolphin has not finished its cycle, turn off the power 1.
supply unit and unplug the mains.
Pull the floating cable gently until the Dolphin has risen to 2.
the surface, then lift by the handle.
Plug the floating cable from the 1.
Dolphin into the power supply unit.
Plug the electrical cable from the power 2.
supply unit into the mains.
Press on the ON/OFF switch. 3.
The Dolphin will now start to work.4.
Note: If your model includes the remote control unit, please refer to the included instruction leaflet.
Important: Do NOT lift the Dolphin from the water by its cable.
Floating cable
On/Off
switch
Important: DO NOT enter the swimming pool while the pool cleaner is working.
To Next Page
Loading...
