Solar Pump Inverter Safety precautions
4
» The encoders and sensors should be applied with the shielded cables and the shielded
layer should be grounded reliably.
4. Operation
Confirm that the wiring is completed and correct and then cover the plate before
power on.
Do not open the plate after power on, otherwise electric shock may occur.
Operate the inverter appropriately, otherwise damage to the inverter may occur.
Non-
professionals are not allowed to test the signals when the inverter is running.
Otherwise, physical injury or damage to the devices may occur.
Any arbitrary change in parameters of the inverter is prohibited, otherwise damage
to the inverter may occur.
Do not touch the fans and brake resistors, otherwise it may cause mechanical injury
or burn.
Do not start up or
stop the inverter by power on or off, otherwise damage to the
inverter may occur.
Ensure that the circuit breakers or contactors at the output sides of the inverter are
not in output state before switching, otherwise damage to the inverter may occur.
5. Others
To Next Page
Loading...
