5
EN
Toilets
3 INTENDED USE
The 4000 Series toilets are designed and intended for use only inside a boat or recreational
vehicle (hereinafter referred to as “RV”) for which it is supplied. Use the instructions to ensure
correct installation of the toilet. Dometic Corporation accepts no liability for damage in the
following cases:
• Faulty assembly or connection.
• Damage to the product resulting from mechanical influences and excess voltage.
• Alterations to the product without expressed permission from Dometic Corporation.
• Use for purposes other than those described in the operating manual.
Dometic Corporation reserves the right to modify appearances and specifications without notice.
4 SPECIFICATIONS
4.1 Materials
Component 4500, 4600, 4700, 4800
Toilet vitreous ceramic
Discharge fitting polypropylene / PVC
4.2 Minimum system requirements
4600, 4800 4500, 4700
Electrical
Circuit breaker 2 amps/12VDC; 1 amp/24 VDC*
Wiring Marine: Refer to ABYC recommendations.
RV: Refer to ANSI/RVIA LV and NFPA 70/NEC Standards
for recommended wire gauge (USA). Refer to CEC I and II
Standards for recommended wire gauge (Canada).
Water Supply
Fitting 1/2" NPT
Flow rate 2.0 gpm/7.6 lpm minimum 2.5 gpm/9.5 lpm minimum
Discharge
Inside diameter 1.5" (38 mm) PVC pipe or sanitation hose
Horizontal run maximum 50' (15 m) from toilet to vacuum source
maximum 20' (6.1 m) from vacuum source to holding tank
Vertical run maximum 6' (1.8 m) from toilet to vacuum source
maximum 6' (1.8 m) from vacuum source to holding tank
* The circuit board contains a resettable fuse that can be reset by turning the electrical power to
the toilet OFF, then ON again.
I
Refer to ANSI 1192 and Z240 RV Series standards, where applicable, for additional RV
toilet installation guidelines. Specifications are subject to change without notice.
To Next Page
Loading...
