Operation ACX35, ACX40, ACX40G
18
➤ Press the control element cover (fig. 2 3, page 4) to open it.
➤ To close the control element cover (fig. 2 3, page 4), push it towards the lid
until it latches.
6.1 Energy saving tips
• Choose a well ventilated installation location which is protected against direct
sunlight.
• Allow warm food to cool down first before placing it in the cooling device to
keep cool.
• Do not open the cooling device more often than necessary.
• Do not leave the cooling device open for longer than necessary.
6.2 Using the cooler in DC mode
➤ Place the cooler on a firm, level surface.
➤ Plug the DC connection cable (fig. 2 2, page 4) into the cigarette lighter socket
in the vehicle.
✓ The cooler starts cooling the interior.
➤ Pull out the DC connection cable to switch off the cooler.
6.3 Connecting to vehicle power
I
6.4 Using the cooler in AC mode
➤ Place the cooler on a firm, level surface.
➤ Plug the AC connection cable (fig. 2 1, page 4) into the AC mains.
➤ Turn the cooling level controller (fig. 3 1, page 5) to the required position.
✓ The cooler starts cooling the interior.
NOTE
If you connect the cooling device to the vehicle power, remember that
you may have to turn on the ignition to supply it with power.
ACX35-ACX40-ACX40G-O-15s.book Seite 18 Freitag, 22. September 2017 6:24 18
To Next Page
Loading...
