Operation ACX35, ACX40, ACX40G
22
6.8 Using the cooler in gas mode
➤ Turn the temperature controller (fig. 3 2, page 5) to the maximum position.
➤ Press and hold the temperature controller.
➤ After 10 seconds, press the ignition button (fig. 3 3, page 5) several times
quickly in succession until the flame is lit.
✓ After ignition, you can see the flame in the sight glass (fig. 2 6, page 4).
➤ Hold down the temperature controller for another 20 seconds.
6.9 Switching off the cooler
➤ Close off the gas valve on the device and on the gas cylinder
6.10 Defrosting the cooler
A
I
➤ Disconnect the voltage and gas supply.
➤ Empty the cooler.
➤ Put a cloth in the refrigerator compartment to absorb any excess water.
➤ Leave the lid open.
➤ Wipe the refrigerator compartments dry with a cloth.
NOTICE!
Never use mechanical tools to remove ice or to loosen objects stuck to
the device.
NOTE
Over time, frost builds up on the cooling fins inside the cooler. If this
layer of frost is about 3 mm thick, you should defrost the cooler.
ACX35-ACX40-ACX40G-O-15s.book Seite 22 Freitag, 22. September 2017 6:24 18
To Next Page
Loading...
Need help?
General
