Operation CK40D
10
6.2 Using the cooler
A
➤ Place the cooler on a firm foundation.
➤ Use the cable to connect the cooler to a 220–240 Vw socket.
➤ Switch the cooler on by pressing the “ON/OFF” button (fig. 2 2, page 3).
✓ The display switches on and shows the current cooling temperature in °C.
✓ The cooler starts cooling the interior.
➤ To switch the cooler off, press the “ON/OFF” button (fig. 2 2, page 3).
➤ The display switches off.
6.3 Setting the temperature
The cooling capacity can be influenced by:
• The ambient temperature
• The number of wine bottles to be cooled
• The frequency with which the door is opened
➤ Press the “TEMP –” (fig. 2 3, page 3) button to decrease the desired cooling
temperature by 1 °C.
➤ Press the “TEMP +” (fig. 2 4, page 3) button to increase the desired cooling
temperature by 1 °C.
✓ The cooling temperature set in °C then appears in the display for a few seconds.
NOTICE! Risk of damage
• Do not switch on the device immediately after transporting it. This
could damage the cooling system. Leave the device to stand for
about 30 minutes after transporting, before you switch it on. This
allows the refrigerant to collect again in the compressor, and the
compressor does not run dry.
• Ensure that the objects or goods placed in the cooling device are
suitable for cooling to the selected temperature.
• Ensure that food or liquids in glass containers are not excessively
refrigerated. Liquids expand when they freeze and can therefore
destroy glass containers.
• Ensure that your cooler is well ventilated so that any heat created can
dissipate. Otherwise proper functioning cannot be ensured. It is
especially important not to cover the air vents.
CK40D_OPM_EMEA16.book Seite 10 Donnerstag, 27. Juni 2019 4:14 16
To Next Page
Loading...
