Using the refrigerator CRX
28
8.2 Switching on the refrigerator
➤ Switch the refrigerator on by pressing the button.
I
8
8.3 Setting the temperature
➤ Press the button repeatedly until the desired temperature level is set. The
lower/largest LED is the coldest setting. The upper/smallest LED is the warmest
setting.To switch from the coldest level to the warmest level press the button
again.
I
8.4 Setting the fast cooling function
(CRX50, CRX65, CRX80 only)
A
The option of operating the refrigerator using a fast-cooling function allows
temperatures suitable for freezing foods to be reached.
➤ Press the button for longer than 3 seconds.
✓ The LED above the button lights up.
➤ Press the button again for longer than 3 seconds to operate the refrigerator in
normal mode.
NOTE
After switching on, the refrigerator needs some time before the com-
pressor starts up.
NOTE
The cooling performance can be affected by:
• The ambient temperature
• The amount of food to be conserved
• The frequency with which the door is opened.
If the ambient temperature is at 16 °C to 20 °C, set the refrigerator to at
least level 2.
NOTICE!
• Only use the fast-cooling function when the removable freezer com-
partment is not installed. Otherwise there is a risk that the freezer
compartment becomes too cold and condensate cannot be pre-
vented from forming on the outside of the refrigerator. The energy
consumption will also increase dramatically.
• Note that bottles and other containers can burst when frozen.
• Note that it is difficult to open the refrigerator directly after closing it.
CRX50-65-80-110-140_IOM_EMEA16.book Seite 28 Mittwoch, 15. Juli 2020 12:51 12
To Next Page
Loading...
