Installation C18B, C46B, D18B, D42B, D46B
22
Control elements
6 Installation
6.1 Selecting the installation location
Observe the following, when selecting the installation location:
• The ambient temperature should be in accordance with the climate class. Other-
wise, it is possible that the inner temperature you set cannot be reached or main-
tained. This could also be the case if there are extreme fluctuations in the ambient
temperature.
The intended ambient temperature use and the climate class can be found in the
technical data (see chapter “Technical data” on page 32) and on the data plate,
which is located at the left on the inside of the wine cooler.
• The ground must be level and sufficiently stable to support the wine cooler at full
capacity.
• The wine cooler must be positioned so that the plug is accessible.
• Note the information on the electrical connection, see chapter “Connecting the
wine cooler” on page 23.
➤ Remove all the inner and outer packaging material before setting up.
Nr. in
fig. 2,
page 3
Symbol Description
1 On/off button
2 Increases the set temperature by 1 °C or 1 °F for top or left zone
3 Decreases the set temperature by 1 °C or 1 °F for top or left zone
4 Temperature display (top or left zone)
5 Temperature display (bottom or right zone)
6 Increases the set temperature by 1 °C or 1 °F for bottom or right zone
7 Decreases the set temperature by 1 °C or 1 °F for bottom or right zone
8 Switches the interior LED lamp on or off
DometicC18B_C46B_D18B_D42B_D46B_OPM_4445103556_EMEA11_xxxx-xx-xx.book Seite 22 Dienstag, 30. November 2021 12:51 12
To Next Page
Loading...
