EasyManuals Logo

Dometic DFSAD12 User Manual

Dometic DFSAD12
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4
OPERATION
FIRE OR EXPLOSION HAZ ARD. Failure to obey the following warnings could result in property damage, serious injury,
or death:
This Furnace does not have a pilot. It is equipped with an ignition device that automatically lights the burner. Do NOT try to light
the burner by hand.
BEFORE OPERATING THE FURNACE, check around the Furnace area and floor for the smell of gas and check the fitting with a
leak test solution. Do NOT proceed if a gas odor exists around the Furnace or floor area. Follow the instructions in the warning box
on the cover page.
Turn the gas control valve by hand ONLY. NEVER use tools. If the valve does not turn by hand, do NOT attempt to repair it. Call a
qualified service technician.
Read the following BEFORE proceeding:
During the initial firing of the Furnace, a burn-off of excess paint and oils remaining from the manufacturing process may cause
“smoking” for 5 – 10 minutes.
The Furnace is equipped with a power switch. Gas will not flow to the burner and the Furnace will not operate with the switch in
the OFF position.
Door models have a power switch located inside of the door.
Non-door models (LD or Small Vent) have a power switch on the outside of the Furnace.
A. Turning On The Furnace
FIG.1
Power
Switch
(Small Vent Models)
FIG.2
*Power
Switch
(Door Models)
*Switch is located behind door
Turn the thermostat to the lowest setting.
Turn OFF all power to the Furnace at the main power supply.
At the exterior access panel, turn the switch on the Furnace to the OFF position.
Wait five minutes, then check for a gas odor.
If a gas odor exists around the Furnace or floor area, follow the instructions in the warning box on the cover page.
If no gas odor is present, proceed to the next step.
At the exterior access panel, turn the switch on the Furnace to the ON position.
Turn ON the main power supply.
Set the thermostat to the desired temperature.
If the Furnace will not operate, follow the instructions for “B. Turning Off The Furnace” on page 5 and call a qualified service
technician.

Other manuals for Dometic DFSAD12

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dometic DFSAD12 and is the answer not in the manual?

Dometic DFSAD12 Specifications

General IconGeneral
BrandDometic
ModelDFSAD12
CategoryFurnace
LanguageEnglish

Related product manuals