Safety instructions DM50C
4
• If this device's power cable is damaged, it must be replaced by the
manufacturer, customer service or a similarly qualified person in order
to prevent safety hazards.
• Do not store any explosive substances such as spray cans with a
flammable propellant in the device.
!
CAUTION!
• Disconnect the device from the mains
– before each cleaning and maintenance
– after every use
• Food may only be stored in its original packaging or in suitable
containers.
A
NOTICE!
• Connect the device with the 230 V connection cable to the 230 V AC
mains supply.
• Check that the voltage specification on the type plate corresponds to
that of the energy supply.
• The cooling device is not suitable for transporting caustic materials or
materials containing solvents.
• Never pull the plug out of the socket by the cable.
I
NOTE
• Do not use an extension cord.
2.2 Operating the device safely
A
NOTICE!
• Do not use electrical devices inside the cooler unless they are
recommended by the manufacturer for the purpose.
• Do not place the device near naked flames or other heat sources
(heaters, direct sunlight, gas ovens etc.).
• Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat that
arises during operation does not build up. Make sure that the device
is sufficiently far away from walls and other objects so that the air can
circulate.
• Ensure that the ventilation openings are not covered.
• Do not fill the inner container with ice or fluid.
DM50C-MB--AUS--EN.book Seite 4 Donnerstag, 1. September 2016 9:08 21
To Next Page
Loading...
Need help?
General
