5
DSP-EM Target group for this instruction manual
The manufacturer accepts no liability for damage in the following cases:
• Damage to the product resulting from mechanical influences and incorrect
connection voltage
• Alterations to the product without express permission from the manufacturer
• Use for purposes other than those described in the operating manual
I
1 Target group for this instruction manual
This instruction manual is intended for qualified personnel who are familiar with
the guidelines and safety precautions to be applied.
2Open service menu
➤ Press the round selector button on the DSP-EM for eight seconds.
✓ The symbol appears.
➤ Release the selector button.
✓ The display shows “S-00”.
3 Navigating within the service menu
➤ Determine the required service codes and values using the following table
(chapter “Service codes” on page 6).
➤ Rotate the selector button until the determined service code is displayed.
The selector button can be turned in both directions. When the last service
code is reached, the display jumps back to the first service code.
➤ Press the selector button to access the sub-menu.
➤ Rotate the selector button until the determined value is displayed.
➤ Press the selector button to save the value.
➤ Set other values if necessary.
➤ Press the selector button until the display is no longer illuminated.
✓ DSP-EM can now be used.
NOTE
Also refer to the operating manuals of the connected devices.
DSP-EM-Service-16s.book Seite 5 Dienstag, 29. Januar 2019 3:08 15
To Next Page
Loading...
