DW6 Using the refrigerator
11
The refrigerator has the following control elements:
I
6 Using the refrigerator
I
6.1 Energy saving tips
• Choose a well ventilated location which is protected from direct sunlight.
• Use the ECO mode of the refrigerator if you want to set a higher energy efficiency and a limited
cooling capacity of the refrigerator.
• Do not open the refrigerator more often than necessary.
• Do not leave the door open for longer than necessary.
No. in
fig. 4, page 3
Description Description
1 POWER Switches the refrigerator on or off.
2 LIGHT Switches the interior light on or off.
3 Display Displays the temperature.
4 TEMP + Increases the cooling temperature by 1 °C (up to
+20 °C maximum).
5 TEMP – Decreases the cooling temperature by 1 °C (up
to +5 °C minimum).
NOTE
You can switch the temperature display between Celsius and Fahrenheit. To do this,
press the TEMP + and TEMP – for approx. three seconds at the same time.
NOTE
Before starting your new refrigerator for the first time, you should clean it inside and
outside with a damp cloth for hygienic reasons (see chapter “Cleaning and mainte-
nance” on page 15).
DW6-O-16s.book Seite 11 Montag, 3. April 2017 4:04 16
To Next Page
Loading...
