HC302, HC502 Cleaning and maintenance
19
7.6 Removing the drawers
You can remove the drawers, e.g for cleaning.
Proceed as follows (fig. 0, page 7):
➤ Open the door (A).
➤ Pull out the drawer (B).
➤ Push the fixing pins from the outside to the inside (C)
➤ Remove the drawer (D)
➤ Assemble the drawers in reverse order.
8 Cleaning and maintenance
!
A
➤ Clean the refrigerator regularly and as soon as it becomes dirty with a damp
cloth.
➤ Make sure that no water drips into the seals. This can damage the electronics.
➤ Wipe the refrigerator dry with a cloth after cleaning.
➤ Check the condensate drain regularly.
Clean the condensate drain when necessary. If it is blocked the condensate
collects on the bottom of the refrigerator.
➤ Regularly clean the door seals.
➤ Freestanding version: Clean the grid of the condenser and the compressor on
the back of the device with a vacuum cleaner regularly.
WARNING!
Always disconnect the refrigerator from the mains before you clean and
service it.
NOTICE!
• Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the refrigerator.
• Never use hard or sharp tools to remove ice or to free objects frozen
onto the device.
• Do not use any mechanical tools or any other tools to speed up the
defrosting process.
HC302-502-IO-EN.book Seite 19 Donnerstag, 16. März 2017 12:11 12
To Next Page
Loading...
