HiPro Using the refrigerator
23
8.4 Switch on the refrigerator
D
!
A
I
➤ Plug the power plug into the socket.
✓ The refrigerator starts a self-test. After about 10 seconds, the LED interior light
illuminates for 2 seconds.
✓ The refrigerator is switched on.
I
8
8.5 Setting the temperature
The refrigerator is equipped with an automatic temperature regulation function. The
cooling temperature is preset to 5 °C.
With the optional remote control you can adjust the preset to 3 °C, 5 °C, 7 °C or
12 °C (fig. i, page 12). With each press of the button on the remote control, the
cooling temperature switches between the possible values:
➤ Remove the plastic insulation from the battery holder before initial use.
✓ By pressing a button, a red LED illuminates on the remote control. If the red LED
does not illuminate, replace the batteries in the remote control.
➤ Align the upper side of the remote control to the LEDs of the interior light (5).
Maintain a distance of less than 20 cm.
DANGER! mortal danger!
Never handle plugs and switches with wet hands or if you are standing
on a wet surface.
WARNING!
Only connect the refrigerator to a correctly earthed socket.
NOTICE!
The power plug must be freely accessible after the refrigerator has been
installed.
NOTE
The refrigerator automatically switches on if it is connected to the mains
supply.
NOTE
After switching on, the refrigerator needs several hours to reach the
cooling temperature within the refrigerator compartment.
HiPro3000_4000_6000_Vision-IO-16s.book Seite 23 Dienstag, 27. November 2018 4:24 16
To Next Page
Loading...
Need help?
General
