MaCave Using the appliance
24
I
Checking the set temperature
This is how to display the set temperature:
➤ Press the or button briefly.
✓ The set temperature is shown in the display for 5 seconds.
Then the display shows the current inner temperature again.
I
Temperature monitoring
A warning signal sounds and the temperature display flashes.
z if the inner temperature of a zone deviates from the set tempera
ture by
m
ore than 5°C.
z if the power supply has been disconnected for a long time.
z if the door has not been shut properly.
z if the door is open for more than 60 seconds.
This prevents the temperature from falling or rising unnoticed, which could
affect the quality of the wine.
Once the unit has reached the set temperature, the warning signal stops and
the temperature display stops flashing.
To switch off the warning signal prematurely:
➤
Press the
button briefly.
✓ The temperature display flashes until the set temperature is reached. T
he
display is
then illuminated constantly and indicates that
the alarm system
is active
again.
NOTE
When using the appliance for the first time or if it has not been
used for a long time, the inner temperature could differ from the
one you have set.
The temperature display flashes as long as this is the case.
Once the set temperature has been reached, the temperature dis-
play remains lit.
NOTE
In the event of an interruption to the power supply (power failure,
switch over) the unit saves the previous temperature settings.
To Next Page
Loading...
Need help?
General
