USE INSTA L L ATION
MAIN T E NANCE
INJECTOR
CLEANING AND/OR REPLACEMENT OF BURNER INJECTORS (FIG. 1 - PAG. 21)
When removing or installing an injector, the holder must be held with a suitable tool.
THE OPERATIONS MUST BE CARRIED OUT BY AUTHORIZED PERSONNEL.
DOMETIC DECLINES ANY RESPONSIBILITY RELATED TO SAID INTERVENTION.
BURNERS HOBBED
NUMBER
AUXILIARY
Ø 47 mm - 1 27/32”
SEMIRAPID
Ø 62 mm - 2 7/16”
RAPID
Ø 77 mm - 3”
57
72
80
0,57
0,72
0,80
ENGLISH
9
TURN OFF THE APPLIANCE AND ALLOW TO COOL BEFORE CLEANING.
COLD WATER OR A DAMP CLOTH MAY DAMAGE HOT SURFACES.
CLEANING
TEST PRESSURE POINT
THE OPERATIONS MUST BE CARRIED OUT BY AUTHORIZED PERSONNEL.
DOMETIC DECLINES ANY RESPONSIBILITY RELATED TO SAID INTERVENTION.
The test pressure point is located on the pressure regulator.
WARRANTY
In case of warranty claim or any repair or replacement which becomes necessary, the vehicle or part dealer who sold
the product should be contacted. Give model and serial number on all repair part orders and correspondence.
DO NOT USE ABRASIVE, CORROSIVE, CHLORIDE-BASED PRODUCTS OR STEEL OR
OTHER SCOURING PADS. DO NOT LEAVE ACIDIC SUBSTANCES E.G. VINEGAR, SALT,
LEMON JUICE ETC. ON THE APPLIANCE SURFACES. STAINLESS STEEL SURFACES
AND ENAMELED PARTS SHOULD ONLY BE WASHED WITH SOAPY WATER OR
NEUTRAL DETERGENT, RINSED AND DRIED. ONLY USE CLEAN SPONGES OR
CLOTHS.
To Next Page
Loading...
Need help?
General
