MFV5M, MF15 Operation
11
6.2 Using the cooling device
A
I
➤ Place the refrigerator on a firm base.
Ensure that the ventilation slots are at least 10 cm away from the wall so that the
heat that arises during operation can be drawn off.
➤ MF15 only:Plug the DC connection cable into the DC socket (fig. 3 2,
page 10) and connect it to DC voltage...or
➤ Plug the AC connection cable into the AC voltage socket (fig. 2 5, page 9 or
fig. 3 1, page 10) and connect it to the AC mains.
➤ Push the switch (fig. 2 4, page 9 or fig. 3 3, page 10) on the control panel to
“HOT”,“COLD” or “MAX COLD” (MFV5M only) to switch the device on.
✓ The refrigerator starts cooling/heating the interior and the appropriate LED lights
up.
➤ If you wish to switch the refrigerator off:
Slide the switch (fig. 2 4, page 9 or fig. 3 3, page 10) to the “OFF” position
➤ Pull out the connection cable.
NOTICE! Risk of damage
• Ensure that the objects or goods placed in the cooling device are
suitable for cooling or warming to the selected temperature.
• Ensure that food or liquids in glass containers are not excessively
refrigerated. Liquids expand when they freeze and can therefore
destroy glass containers.
• Ensure that your cooler is well ventilated so that any heat created can
dissipate. Otherwise proper functioning cannot be ensured. It is
especially important not to cover the air vents.
NOTE
MFV5F only: For use as a milk cooler for coffee makers the refrigerator
has holes in both sides sealed with a black plug.
Remove the plug and push the milk tube into the appliance. The coffee
maker can draw up cold milk directly from a suitable vessel inside the
refrigerator.
Seal the opening on the side of the appliance with the plug if you do not
use the milk tube.
MFV5M-MF15-O-EN.book Seite 11 Dienstag, 1. August 2017 10:17 10
To Next Page
Loading...
Need help?
General
