Safety and installation instructions PerfectView M55L, M75L
10
•
The following data must be reset, depending on the vehicle equipment options:
– Radio code
–Vehicle clock
–Timer
–On-board computer
–Seat position
You can find instructions for making these settings in the operating manual.
Observe the following installation instructions:
!
Observe the following instructions when working with electrical parts:
•
When testing the voltage in electrical cables, only use a diode test lamp (fig. 1 1, page 2) or a
voltmeter (fig. 1 2, page 2).
Test lamps with a bulb (fig. 1 3, page 2) consume voltages which are too high and can
damage the vehicle's electronic system.
•
When routing the electrical connections, ensure that:
–They are not kinked or twisted
–They do not rub on edges
–They are not laid in sharp-edged ducts without protection (fig.3, page 3).
•
Insulate all connections.
•
Secure the cables against mechanical wear by using cable binders or insulating tape,
for example on existing cables.
Observe the following instructions when handling the LCD monitor:
!
CAUTION!
•
Secure the monitor in such a way that it cannot become loose under any
circumstances (sudden braking, accidents) and cause injuries to the occupants
of the vehicle.
•
Do not attach the monitor in the air bag deployment path, as this could cause injury
if the airbags are triggered.
CAUTION!
•
People (including children) whose physical, sensory or mental capacities or whose
lack of experience or knowledge prevent them from using this product safely
should not use it without the supervision or instruction of a responsible person.
•
Do not open the monitor (fig. 4, page 3).
•
Do not submerge the monitor in water (fig. 5, page 3); the monitor is not
waterproof.
•
The monitor must not impair your vision when driving (fig. 8, page 4).
•
Do not operate the monitor with wet hands.
•
Do not operate the monitor if the housing has been damaged.
M55L-M75L-IO-16s.book Seite 10 Mittwoch, 20. Dezember 2017 12:32 12
To Next Page
Loading...
Need help?
General
