PR2000, PR2500 Operating the awning
21
A
Retracting the awning using a 12 V motor (only PR2500, optional)
➤ Press the button of the switch or the remote control until the awning is only
extended by about 1.5 metres. Position the struts vertically and back under the
front panel every 30 cm so that the awning stays secured at all times.
➤ Fold the lever of the right strut down to loosen the struts.
➤ Slide the struts together completely.
➤ Fold the right strut up.
➤ Turn the right strut into the front panel.
➤ Slide the bottom part of the right strut into the latch of the front panel.
➤ Retract the other strut in the same way.
➤ Press the button of the switch or the remote control until the awning has been
completely retracted.
➤ Double-check that the awning is fully retracted before starting your journey. The
front panel should be right up against the housing.
A
7.4 Adjusting the 12 V motor (only PR2500, optional)
I
If the awning no longer fully closes or opens, adjust the 12 V motor (fig. d, page 9).
NOTICE! Beware of damage.
If the awning is retracted when wet, extend it again and let the fabric dry
out at the next opportunity. If the wet fabric stays rolled up for a long
time, mildew will form and the fabric can fade.
NOTICE! Beware of damage.
If the awning is retracted when wet, extend it again and let the fabric dry
out at the next opportunity. If the wet fabric stays rolled up for a long
time, mildew will form and the fabric can fade.
NOTE
The 12 V motor is pre-assembled in the roller tube.
PR2000_PR2500-O-16S.book Seite 21 Donnerstag, 5. Oktober 2017 10:23 10
To Next Page
Loading...
