8
Scope of supply4.2
Mounting material (awning length 256 cm to 406 cm)
2x Bottom rafter mounting bracket
8x Sheet metal screw
3x Mounting bracket
3x Self-drilling pan head cross screw
24x Carriage bolt
12x Split lock washer
12x Flat washer
12x Self-locking nut
Additional mounting material (awning length 456 cm to 506 cm)
1x Mounting bracket
1x Self-drilling pan head cross screw
4x Carriage bolt
4x Split lock washer
4x Flat washer
4x Self-locking nut
Assembly
Installation notes
4.0
4.1
Warning!
Damage by inadequate handling.
• Installation and operating instructions should be read carefully!
• Installation should only be done to even inside and outside walls!
• Choose installation place in a way to prevent damages to adjacent parts
(roof railing, mounting and reinforcing parts), cables, fixtures and cabinets
inside the vehicle.
• Mounting position should be sealed with adequate sealing compound.
• Please observe minimum clearance between lower edge of case and door
(80 mm)! Allow for at least a 10 to 15-degree pitch of of fabric of the
awning.
• Be sure the door will open when the awning is completely extended.
• Awnings with lengths exceeding 350cm need an additional middle sup-
port.
ENGLISH
To Next Page
Loading...
