instructions
for installation:
The
design of this refrigerator has been certified by the American
Gas
Association.
Before using your refrigerator, you should wipe it inside and outside
with
lukewarm water
containing a mild detergent. From time to time, the PVC-seal of the lid should be rubbed
with
a
little talcum powder.
1.
Installation:
The
installation of
the
refrigerator must conform to the following American
National
Standards,
as
applicable:
ANS 221.74-b
-1989
Portable Refrigerator; in Canada: CAN1 -11.4-M79
The overall dimensions of the refrigerator are given in fig. 1.
For installation; for maintaining proper clearances between combustible
material
and the
refrigerator, the following minimum clearances must be observed:
clearance from rear edge to outer casing of refrigerator:
4 inches
clearance above top of refrigerator lid:
min. 6 inches
clearance at sides of refrigerator casing:
0 inches
Fig.
1.
illustrates these minimum clearances.
223’
Floor
level
installation
Refrigerator
cabinet
may
be installed with 0 Inch
clearance to rider from
Fig.1
combustibles
2
To Next Page
Loading...
