RCD10.5XES Troubleshooting
35
12 Troubleshooting
In the event of a fault, the warning LED ( ) in the display flashes according to the fault.
All faults of the WARNING (W) type are reset automatically once the fault has been rectified.
All faults of the ERROR (E) type must be reset manually:
➤ Press the button for 2 seconds.
✔ A beep sounds.
✔ The error has been reset.
13 Warranty
If the product does not work as it should, please contact your retailer or the manufacturer's branch in your country
(see dometic.com/dealer). The warranty applicable to your product is 3 year(s).
For repair and warranty processing, please include the following documents when you send in the device:
• A copy of the receipt with purchasing date
• A reason for the claim or description of the fault
Australia only
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled
to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality
and the failure does not amount to a major failure.
Number of
flashes
Audio alarm Fault type Fault Solution
Continuous No W Defective tempera-
ture sensor in the
refrigerator com-
partment
➤ Contact an
authorized cus-
tomer service
point.
1 Yes W DC voltage
<10.0–31.5V
Resets automatically
2 Yes E Outer fan overcur-
rent
➤ Press the on/off
button for at
least 2 seconds.
3 Yes E Compressor does
not start
➤ Press the on/off
button for at
least 2 seconds.
4 Yes E Compressor over-
load
➤ Press the on/off
button for at
least 2 seconds.
5 Yes E Thermal cut out
compressor con-
troller unit
➤ Press the on/off
button for at
least 2 seconds.
6 No W CI bus fault Resets automatically
– Yes W Door open for more
than 2 minutes
➤ Close the door.
To Next Page
Loading...
Need help?
General
